Search:

Type: Posts; User: jimbo70

Search: Search took 0.02 seconds.

  1. Replies
    1
    Views
    1,793

    Re: Queensland - Marinas, Anchorages

    My stomping ground is mainly between the northern side of Shoal water bay and 1770. As far as anchorages go any small waterway with access at or about low tide is good value ... finding the channel...
  2. Replies
    6
    Views
    3,396

    Re: Seawind 24 Tasmania

    Hi Dan .... I'm John (JIMBO) You seem to be the last person to create a thread hence this reply
    Is this forum defunct?
    If so can I communicate with you via email or 'phone (I'm a Queenslander)....
  3. Replies
    4
    Views
    1,688

    Re: Seawind 24 Rotating Mast Bushing

    I am currently refurbishing my mast including the bush. I have turned down a cylinder of nylon. Scaling dimensions from photos I have made the wafer approx 10mm thick and made it wider than the brass...
  4. Replies
    37
    Views
    14,394

    Re: New owner, old boat Seawind 24

    where abouts are you Wade ? I'm West of Rocky. I had a look at the bowen boat via google earth at work & it didnt look all that good .... neglected would be a good description.
    In relation to...
  5. Replies
    85
    Views
    34,918

    Re: seawind 24 hard decks

    Zed Mate I'm looking at ply or foam decks too ... actually a composite 6mm ply (bryunzeel with temanto triangular strips+ epoxy & woven rovings as transverse stiffeners.
    When I was a lad I built &...
  6. Replies
    37
    Views
    14,394

    Re: New owner, old boat Seawind 24

    pagu did u buy the cat in Bowen ?

    the last one I shifted we dismantled it and put in on a car float. best behind a ute so the mast can legally overhang the car. take a number of tyres for packing...
  7. Replies
    7
    Views
    2,680

    Re: Trailer Plans for Seawind 24 Trailer?

    Could you make life a lot easier for me by supplying the dimensions horizontally and vertically between the rollers. I'm at that stage in the building of my trailer also looking at making the trailer...
  8. Replies
    60
    Views
    35,772

    Sticky: Re: New Members Please Read

    no worries .... I should apologize for not responding to your welcoming instructions before posting.
    I'm a north australian who kicked off in a mates arrow and graduated to my own mosquito thence...
  9. Replies
    7
    Views
    2,680

    Re: Trailer Plans for Seawind 24 Trailer?

    I have seen an au factory built trailer and the boat seemed to sit a lot higher off the ground. It also carried a lot more rollers approx every foot. I'm in the process of building a trailer and am...
  10. Replies
    4
    Views
    1,528

    Re: Seawind 24 mast stays

    they are all the same because the SW has a rotating mast and thus needs a single attachment point with the rotating mast mast base as the bottom end.
Results 1 to 10 of 10